Installation Steps of Constant Temperature Shower Column

Installation steps of Constant Temperature Shower Column
1. The installation of the Constant Temperature Shower Column mainly includes the installation of the top shower head, the middle shower installation and the installation of the knob. Generally, we need to check whether the parts, materials and tools of the shower column are ready before installation, and keep the installation area clean and tidy.
2. Under the proper conditions to ensure that the materials are complete and the installation environment is suitable, we will start the installation. First, connect the Constant Temperature Shower Column joint with the pre-embedded water pipe joint. When connecting, pay attention to wrap the raw material tape on the joint to keep its tightness and prevent water leakage.
3. Pay attention to the distance when installing, mainly the distance between two large and small showers. Generally speaking, the distance between the two showers is between 90cm-100cm according to the installation standard. Of course, you can make appropriate adjustments according to your personal needs during installation.
4. At this time, we need to connect the faucet and the main body of the Constant Temperature Shower Column, and determine the specific position of the installation base on the wall, drill the hole according to the determined position, put in the nylon anchor, and then use the self-tapping screw to handle it. Fixed to the wall. What needs to be done afterwards is the connection between the faucet and the eccentric joint box fixing seat. When connecting, the main attention should be paid to the sealing gasket between the faucet body nut and the eccentric joint.
5. Finally, we install the nozzle, install the top nozzle on the outlet elbow, ensure that the connection between the two is firm, and check whether the sealing performance is good. The most annoying thing when using the Constant Temperature Shower Column is the water leakage, so after the installation is completed, we still need to carry out the acceptance work. Open the angle valve and check if there is any water leakage under the condition of ensuring the water flow. If there is water leakage, you can reinstall it.