Home > News > Industry News

Precautions for installation and use of thermostatic shower faucet.

2021-09-17

* Users with more impurities in tap water are not suitable for thermostatic faucets;

* If the tap water contains powdery sediment or soft foreign matter, it may reduce the sensitivity of the thermostatic valve core, and may also shorten the service life of the thermostatic faucet;

* Shorten the distance between the water heater and the faucet as much as possible, so that the hot water can reach the faucet as soon as possible;

* Normal use water pressure is 0.05Mpa ~ 0.6 Mpa;

* The hot and cold water supply pipe must not be installed wrongly, the hot water pipe must be on the left, and the cold water pipe must be on the right;

* Be sure to clean up the installation site before installing the thermostatic faucet, so as not to damage the rubber ring, thread, thermostatic valve core and other parts of the faucet by small sand and hard blocks;

* Please install according to the instructions of the manual, pay special attention not to miss, lose or damage any gaskets or rubber rings;

* The thermostatic faucet itself has no heating function, please adjust the water temperature of the water heater to 60℃~70℃;

* The shower and the shower pipe cannot withstand the high temperature above 60℃;

* After each use, please be sure to adjust the water temperature adjustment knob on the left to below 40℃;

* If the water pressure of hot water and cold water is too different, please use a screwdriver to adjust the valve of the bracket. Households using gas water heaters need to pay more attention to this. 



X
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy
Reject Accept